CRL Brushed Nickel No-Drill Fixed Panel Glass Clamp for 3/8" or 5/16" Glass
Made of solid brass, and available in numerous stock finishes, these CRL No-Drill Fixed Panel Clamps provide an alternative to Clamps requiring drilled holes or notches in the glass. Two nylon tipped set screws are tightened to secure the glass. Mounting screws are also provided for the wall/ceiling/floor. Silicone must also be used for reinforcement along all glass edges where Clamps are used.
IMPORTANT NOTE: Do not hinge a door off a fixed panel using these Clamps. Clamps must be used on minimum of three sides of fixed panel (top, bottom, and at least one side). Silicone must be used for reinforcement along the entire edge of the glass where Clamps are used. It is the responsibility of the installer to determine if adequate structural backing support is being used.
Made of Solid Brass | No Glass Fabrication Required | Includes Clear Gaskets and Mounting Screws | For 3/8" or 5/16" (10 or 8 mm) Glass | Use Monolithic Tempered Glass
We Also Recommend
CRL Co-Extruded Clear Bottom Wipe with Drip Rail for 3/8" Glass - 31-5/8 in long
CRL Sliding Glass Door Roller with 1-1/8" Steel Wheel 5/8" Wide Housing for Capital Mfg. Doors - D1596
C.R. LAURENCE A203 CRL 5/16" Wide Sliding Screen Door Latch Strike With 1/2" ...